Publicidad
Idiomas disponibles
Idiomas disponibles
44
PROGRAMMING MODE
1.
Pressing the Start button cycles to the next test function.
Number of times
the Start
button is pressed
None
Check the version and code of ma-
chine.
Electric Coin type : P4:OE
Electric Card type : P4:CE
1 time
Electric OPL type : P4:PE
Gas Coin type : P4:Og
Gas Card type : P4:Cg
Gas OPL type : P4:Pg
2 time
PDA CHECK
3 time
Motor runs.
GAS TYPE: Blower Motor runs
4 time
ELECTRIC TYPE: Heater runs.
Motor + Heater 1
GAS TYPE: GAS valve runs
Drum Motor + Blower Moror + Valve
5 time
ELECTRIC TYPE: Heater runs.
Motor + Heater 1 +Heater 2
LED & KEY CHECK
Press High Temp. button.
6 time
Press Med Temp. button.
Press Low Temp. button.
Press No Heat button.
7 time
Test ends.
Door switch
(Drum Motor & Blower Motor &
During check, if the
Heater Off, Buzzer seven times)
Door or LintFilter is
LintFilter switch
open
(Drum Motor & Blower Motor &
Heater Off, Buzzer seven times)
During check, if the
Test goes back at step 3.
door is closed
(Motor on & Heater Off )
NOTE
Do not use
.
Checking point
Display
LqC 1
Version and code of machine (All LED on)
Display P4:XX and tU:XX and td:XX alternately.
XX is product type or the version number.
Ir--
Measured moisture value (70~239)
Blower Motor RPM (~3000)
Current temperature (5~70)
(Displays the temperature inside the drum in ° Celsius.)
Display the blower motor RPM and the temperature
inside the drum in Celsius alternately
1.Blower Motor RPM (~3000)
2.Current temperature (5~70)
(Displays the temperature inside the drum in ° Celsius.)
Version and code of machine
LqC1
dE (the door or lint filter is open. Please close the door
and lint filter completely)
Measured moisture value (70~239)
Publicidad
