Publicidad
Idiomas disponibles
Idiomas disponibles
Before you start
Assembly
Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Loop handle version
Loop handle assembly
U-handle version
U-handle assembly
Installation of shield
WARNING
Assemble loop handle and bracket to drive shaft assembly.
Fit protrusions of loop handle (A) and bracket (B) into the respec-
tive concaves of cushion (C) and make sure they are firmly dove-
tailed with each other and fasten screws (M5×35) (D).
Loosen bolts (M5×25) and adjust handle to a position that makes
operation comfortable. After adjustment fasten bolts (M5×25)
tightly to fix handle.
Install the handle so that it does not hide any of the
safety decals.
1.
Install handle assembling bracket (upper) (A) in handle as-
sembling bracket (lower) (D) and fix handle by tightening
handle assembling bolt (8 mm) (B) lightly.
2.
Adjust inclination of handle to adequate position (easy to op-
erate) and tighten firmly handle assembling bolt.
C: Washer
1.
Fit shield (A) to mounting portion of angle transmission and
tighten 4 bolts (B).
10
CAUTION
Publicidad
