Descargar Imprimir esta página

Echo SRM-420TES Manual De Instrucciones página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

Installing nylon line cutting head
Adjusting the balance
Adjusting the shoulder harness
This product is designed to fit a wide variety of body sizes, but may not be adjustable for extremely tall persons. Do
not use the unit if your feet can reach the cutting attachment when the unit is attached to the harness.
A person's size can affect the balancing adjustment. Also the balancing procedure may not work with some units on some
persons. If the shoulder harness does not fit you or cannot be adjusted well, please ask your dealer for assistance.
Balance tool for a level plane of cutting head rotation
Preparing the fuel
Do not fuel up while the engine is hot or in operation.
Do not smoke or hold a flame near when refuelling.
If you do so, the fuel could ignite and cause fire, leading to burns.
Fix output shaft securely using locking tool in order to
prevent it form rotating when nylon cutting head is
mounted.
1.
Insert locking tool into a hole located on the right side of an-
gle transmission while forcing retainer spring to the left side.
2.
Insert locking tool further into blade retainer fixing slot (A) to
fix output shaft.
3.
Thread nylon line cutting head (B) onto shaft (anticlockwise)
until it is tight.
4.
Remove locking tool (C).
WARNING
IMPORTANT
The accompanying shoulder harness is suitable for people of
standard adult physique, who are 150 cm - 195 cm in height
and 60 cm - 140 cm in waist size.
Use a shoulder harness when provided or when recommend-
ed in this manual. Adjust both harness and the suspension
point (A) on the unit so the unit hangs with the cutting attach-
ment a few centimetres above ground level (B).
The cutting attachment and shield should be level in all direc-
tions. Harness the unit on the right side as shown.
DANGER
11
Before you start
CAUTION

Publicidad

loading