Krups SAVOY EC314 Manual Del Usuario página 8

■ Close the lid (b).
■ Press the brew button(k). The button lights up to indicate that the coffee maker has begun the brew cycle.
It beeps once. Fig. 11.
■ When the cycle has ended, the 'keep warm' feature turns on automatically (the countdown showing the
time during which it will remain warm is displayed on screen). The brew button (k) flashes slowly.
■ After the default keep warm time of 30 minutes your appliance beeps 3 times and the brew button (k)
switches off.
■ At any time during the brew cycle, you may turn off the coffee maker by pressing the brew button (k). The
light on the brew button will also go out. It beeps 3 times prior to turning off.
Even if the brew cycle has ended, there is still hot liquid in the filter. Wait a few minutes for the rest of the
liquid to flow into the carafe before removing the filter.
Note :
- The amount of coffee in the carafe at the end of the cycle is less than the amount of water poured into the
water tank, since the ground coffee and the filter absorb about 10% of it.
- The water tank is equipped with an overflow outlet at the rear of the appliance. If you add too much water,
it will come out of this opening.
- Clean the permanent filter in between each use, or use a paper filter.
CAUTION:
- To avoid overflowing, the carafe should be properly placed on the warming plate of the coffee
maker, otherwise the hot water or hot coffee may overflow.
- The coffee maker becomes very hot during the brew cycle. Handle it carefully.
6. OTHER FEATURES
6a – AUTO START FUNCTION
Programming the auto-start settings.
■ Your appliance is equipped with two auto-start programs.
■ Check whether the clock is set to the right time. If not, follow the instructions in the SETTING THE CLOCK
section.
■ Press the AUTO ON button. An AUTO 1 icon displays on screen. Fig. 12.
■ Turn the brew knob (k) to set the time. Validate by pressing the brew button (k). The time is displayed. Fig. 13
and 14.
■ Without validation with the brew knob (k), the time is recorded automatically after about 5 seconds.
■ To set the second program, push the AUTO ON button twice, so that the AUTO 2 icon appears on screen.
Fig. 15.
■ Turn the brew knob (k) to set the time. Validate by pressing the brew knob (k). The time is displayed. Fig. 16
and 17.
■ If you do not confirm using the brew knob (k), the time is recorded automatically after about 5 seconds.
Activate a delayed start-up where the time is already regulated.
■ Select AUTO 1 or AUTO 2 by pressing the AUTO ON button. Press the brew button (k) to launch auto-
start program.
6b – REGULAR OR BOLD
■ This feature allows you to make a coffee that is more or less full-bodied.
■ The BOLD feature increases the time of the cycle for a stronger coffee.
■ Press the REGULAR or BOLD button to select the intensity of your coffee. Fig. 18.
■ The REG or BOLD icon appears on screen.
■ The feature is stored in the memory for subsequent cycles.
10