Publicidad
Idiomas disponibles
Idiomas disponibles
2)
the location shown in the Unifit Rough-
In installation instructions found in
the Rough-In box (see Illustration 2).
anchors).
3) Turn the PVC outlet connection upside
down. Firmly press a new wax seal
onto the circular recess around the
outlet opening. Turn the outlet connec-
tion upright and lower it into position
properly aligned, press down firmly to
set the wax seal (see Illustration 3).
CA UTION: Do not move the outlet
connection after the wax seal is set.
4) Insert the washers and thread nuts
onto the mounting bolts and hand-
tighten (see Illustration 4). Then tighten
bolts an additional ½ turn. Secure the
back side of the outlet connection to
ers.Insert the T-bolts into the slots with
the head down and threaded shank
pointed upward.
NO TE: Level the PVC outlet. Do not
use excessive force.
5) Lift the toilet and gently lower it into
lustration 5). Make sure that the spigot
outlet of toilet slips into the rubber
sleeve and that the T-bolts fit through
the openings in the base of toilet.
Insert the washer and thread nuts
onto the bolts and hand tighten. Then
tighten the bolts an additional ½ turn.
Install the cover plates.
WA RNING! Do not over-tighten the
nuts. Damage to china or plastic
parts may result.
INSTALLATION PROCEDURE
-
4
Ill. 2
2"
Ill. 3
Ill. 4
T-Bolts
-
Slot
Ill. 5
Nut
Washer
Cover
Plate
Finished Wall
Floor
B
C
A
Closet Flange
Wax Seal
Spigot
Outlet
Rubber
Sleeve
C/L
Nut
Bolt
Publicidad
