Descargar Imprimir esta página

Genesis GLRS20A Manual Del Operario página 4

Sierra alternativa de litio-ion de 20v

Publicidad

Idiomas disponibles

Idiomas disponibles

Turn power tool off, and disconnect the plug
from the power tool before making any adjustments, changing the accessories, or storing the tools. Such
preventive safety measures reduce the risk of an accidental start up which may cause personal injury.
Store idle tool out of reach of children and other inexperienced persons
dangerous in the hand of untrained users.
Maintain power tools with care
component breaks, and any other conditions that may affect the tool's operation. A guard or any other part that
is damaged must be properly repaired or replaced by an authorized service center to avoid risk of personal
injury.
Use recommended accessories
manufacturer or intended for use on this type tool may cause damage to the tool or result in personal injury to
the user. Consult the operator's manual for recommended accessories.
Keep cutting tools sharp and clean
are less likely to bind and are easier to control.
Feed the workpiece in the correct direction and speed.
blade, cutter, or abrasive surface against the direction of the cutting tool's direction of rotation only. Incorrectly
feeding the workpiece in the same direction may cause the workpiece to be thrown out at high speed.
Never leave the tool running unattended, turn the power off
until it comes to a complete stop.
BATTERY TOOL USE AND CARE
Ensure the trigger switch is in the off position before inserting battery pack.
Inserting the battery pack into power tools that have the switch on invites accidents.
Recharge only with the charger specified by the manufacturer.
suitable for one type of battery pack may create a risk of fire when used with another battery pack.
Use battery tools only with specified battery pack
create a risk of injury and fire.
Avoid storing battery pack in a container with other metal objects such as
nails, coins, clips, keys, screws, or other small metal objects that can make
a connection from one terminal to another
battery pack is not being used. Connecting the battery terminals together may cause burns or a fire.
Under abusive conditions, liquid may be ejected from the batter
If contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek medical help. Liquid
ejected from the battery may cause irritation or burns.
Battery tools do not need to be plugged into an electrical outlet
always in operation condition. Be aware of possible hazards when not using your battery tool or when changing
accessories. following this rule will reduce the risk of electric shock, fire or personal injury.
WARNING:
OTHER AIRBORNE PARTICLES, INCLUDING WOOD DUST, CRYSTALLINE SILICA DUST
AND ASBESTOS. Direct particles away from face and body. Always operate tool in a
well-ventilated area and provide for proper dust removal. Use dust collection system
wherever possible. Exposure to the dust may cause serious and permanent respiratory
or other injury, including silicosis (a serious lung disease), cancer, and death. Avoid
breathing the dust, and avoid prolonged contact with the dust. Allowing dust to get into
your mouth or eyes, or lay on your skin may promote absorption of harmful material.
Always use properly fitting NIOSH/OSHA approved respiratory protection appropriate for
dust exposure, and wash exposed areas with soap and water.
SERVICE
• Have your power tool serviced by a qualified repair person
replacement parts. This will ensure that the safety of the power tool is maintained.
• Service your power tool periodically.
portion of the tool since internal wires may be misplaced or pinched.
4
. Check for proper alignment and binding of moving parts,
. using accessories and attachments not recommended by the
USE OF THIS TOOL CAN GENERATE AND DISBURSE DUST OR
20V
MAX Lithium-ion Reciprocating Saw
Operator's Manual
from the power source and/or battery pack
. Properly maintained cutting tools with sharp cutting edges
. use of any other battery packs may
. Always protect the battery terminals when
When cleaning a tool, be careful not to disassemble any
GLRS20A
. It is
feed the workpiece into a
. Do not leave the tool
A charger that is
y. Avoid contact.
, therefore, they are
using only identical

Publicidad

loading