CMT ORANGE TOOLS CMT400 Manual De Instrucciones página 15

WorK safetY
1 - Always switch off and unplug the drill when changing the drill bits or setting drilling depth.
2 - Do not touch rotating parts while drilling.
3 - Use ear protection.
4 - Always wear a dust mask or respirator.
5 - Do not wear loose clothing. Make certain loose sleeves have been rolled up or held closed and
do not wear a tie.
6 - Before switching on the drill, make certain the drill bit is well tightened and the stop ring is
secured.
7 - Prevent the drill from unexpectedly switching on: make certain the drill switch is not in the "on"
position before plugging in.
8 - Wait until the drill has switched off completely before carrying out any adjustment work or tool
change.
cMt400 – cMt656 spare parts list
pos. # Description
1 Drilling template body for CMT400
Drilling template body for CMT656
2 Clamps (complete)
3 Edge stop pin Ø10x10
4 M4x16mm countersunk philips screw
5 Centering pin Ø8/18mm
6 6mm hex key
cMt400-1 - cMt400-2 spare parts list
pos. # Description
1 Centering bush w. bearings for CMT400-1
Centering bush w. bearing for CMT400-2
2 Chuck shaft (L125mm) for CMT400-1
Chuck shaft (L140mm) for CMT400-2
3 Stop ring Ø9X17X6mm
4 Spring Ø10/12x65mm
5-6 M4x4mm hex grub screws
7 2mm hex key
8 Centering pin Ø5mm for CMT400-2
9 Centering pin Ø7mm for CMT400-2
www.cmtutensili.com
WorK safetY anD spare parts List
pieces
1
1
2(CMT400)-3(CMT656)
2
1
2
1
(not included in the package)
pieces
CMT400-3
CMT400-02
CMT400-03
CMT900-18
991.066.00
1 CMT400-11
1 CMT400-21
1 CMT400-12
1 CMT400-22
1 CMT400-13
1 CMT400-14
2 990.016.00
1 991.060.00
1 CMT900-15
1 CMT900-17
code
code
15