Descargar Imprimir esta página

CMT ORANGE TOOLS CMT400 Manual De Instrucciones página 3

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Use of CMT400 and CMT656 drilling system
The CMT400 and CMT656 drilling system is designed for making corner joints for furniture elements
with dowels, for boards from 18 to 45mm thick, or with 40-50-60mm screws, for boards from 18 to
30mm thick using a hand, battery or power drill with the CMT400-1 or CMT400-2 adaptor chuck.
Thanks to the carefully studied design of the drilling bush, a wide range of drill bits can be used for
drilling holes for dowels with various diameters. The CMT400 and CMT656 system increases the
quality and precision of dowel or screw joints. The entire system is based on the use of the drilling
template with the adaptor chuck on which a drill bit with HW cutting edge is fitted. Thanks to the
simple construction, maximum precision of the drilling template and adaptor chuck, it is possible to
obtain precise dowel or screw joints. Making a corner joint takes about 10 - 20 minutes, depending
on joint size.
The following are required to use the system:
- Electric and cordless drill
- CMT400-1 chuck adaptor
- CMT400-2 chuck adaptor (holes for 40-50-60mm screws)
- Blind hole bits with Ø8mm shank
306.080.11 _ D8x30 S8mm bit for HW CMT400-1 dowels (blind holes)
307.050.11 _ D5x40 S8mm bit for HW CMT400-2 dowels (blind holes)
307.070.11 _ D7x40 S8mm bit for dowels HW CMT400-1 (through holes for screws)
www.cmtutensili.com
DESCRIPTION AND USE OF CMT400 AND CMT656
3

Publicidad

loading

Este manual también es adecuado para:

Cmt656