Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND ASSEMBLY
ST-24W / ST-24WOSC
Tools Needed:
•
Electric screwdriver
The wall fan must be mounted on 12 inch (300mm)
thick dry and cement - grouted firm wall or on 4 by
5 inch wood studs / joists. Use wall bracket as a
template for locating the holes to be drilled.
After determining the hole locations, use an
appropriately sized drill bit and drill holes through
mounting surface. It is recommended that a minimum
of grade 5 fasteners be used. The following are
acceptable surfaces for mounting wall mount
assembly.
1.
Install the wall bracket following installation
instructions.
Install the fan motor on the angle support bracket.
2.
Assembling the back guard, blade, front guard to
3.
the motor.
Front
Guard
Set
Screw
Fan
Blades
Screw
STEEL SURFACE: When mounting to a steel surface,
such as a vertical I-beam, drill through holes at pre-
marked locations, using a 9/32" drill bit. Attach wall
mount assembly to mounting surface using 1/4"-20 hex
screw, in combination with 1/4" flat washers, 1/4" lock
washers, and 1/4"-20 hex nuts.
MASONRY SURFACE: When mounting to a masonry
surface, use a 1/4" expansion type bolt or 1/4" masonry
lag with sheild. Drill holes at pre-marked locations
using an appropriately sized drill bit as recommended
for fastener.
NOTE: HARDWARE NOT SUPPLIED
Rear
Guard
Pivot (Bolt, Washer, Nut)
Wall Bracket
Angle Support Bracket
Position Screw
ENGLISH
Motor
Wall
Bracket
3
Publicidad
