Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
BEFORE PLUGGING IN
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example, in a wet basement or near a sink.
• This appliance is intended for indoor household
and garage use only. Freezers are tested to
perform in temperatures ranging from 0°F to
110°F (-17°C to 43°C). It is not designed for
outside installation, including anywhere that
is not temperature controlled such as porches,
vehicles, etc.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
REQUIRED SPACE
This appliance is 54.4 cm (21.4 inches) wide by
142.5 cm (56.1 inches) high by 57.1 cm (22.5
inches) deep.
Allow enough space on at least 2 sides to let the
door open fully.
LEVELING INSTRUCTIONS
There are two adjustable feet on the bottom of the
appliance that can be turned up or down to ensure
that the appliance is level. To level the appliance:
1. Turn the adjustable feet counter-clockwise until
the top of the feet are touching the bottom of the
cabinet.
2. Slowly turn the adjustable feet clockwise until the
appliance is level.
3
Publicidad
