Publicidad
Idiomas disponibles
Idiomas disponibles
1. ASSEMBLY
INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there:
The assistance of a second person
is recommended when assembling
this unit Fig.1.
(43) Main body.
(73) Main post.
(78) Handlebar tube.
(67) Front stabiliser bar with wheels.
(46) Rear
stabiliser
adjustable feet.
(16L) Left footrest.
(16R) Right footrest.
(17L) Pedal left foot.
(17R) Pedal right foot.
(5L) Top focus bar, left.
(5R) Top focus bar, right.
(1)
Monitor.
(12) Focus bar spindle covers (L).
(12) Focus bar spindle covers (R).
(18) Bottom trim covers, left and
right. (L) for the knuckle joints on the
focus bars.
(23) Bottom trim covers, left and right
(R) for the knuckle joints on the focus
bars.
(52) Bottom cover, left foot.
(52) Bottom cover, right foot.
(70) Bottom post cover.
Fig.2 NUTS & BOLTS
(8)
Screws M-8x20.
(4)
Flat washer 8x36.
(10) Flat washer 19,5x38x0,5.
(9)
Spring washer M-8.
(64) Corrugated washer M-8.
(65) Self-locking nuts M8.
(47) Screw DIN 603 M-8x60.
Allen key 5 mm
Box spanner.
2. FITTING THE STABILISER
BARS.-
Bring the front stabiliser bar with
wheels (67) to the main body (43)
positioning the wheels at the front of
the unit, Fig.3, insert screws (47), fit
the spring washers (9) and the
corrugated washers (64). Use the
5mm Allen key to tighten securely.
Take the rear stabiliser bar with
adjustable feet (46), Fig.4, insert the
bar
with
bolts (47); fit the washers (9), the
corrugated washers (64) and tighten
securely.
3. FITTING THE BOTTOM
POST COVER.-
Take the main post (73) and insert the
bottom post cover (70) in the direction
of the arrow, Fig.5.
4. FITTING THE MAIN POST.-
Once the bottom post cover is fitted,
remove the screws (72) and washers
(9) and (64) from the bottom of the
main post (73).
Bring the main post (73) up to boss on
the main body (43), Fig.6.
Take the tip of the tension cable (77),
sticking out of the bottom of the main
post (73) and connect it to the tension
support (68), as shown in Fig.6A.
Plug connector (71), coming out of the
main post (73), into connector (69),
coming out of the boss on the main
body (43), Fig.6A.
Slip the main post (73) over the boss
(43) on the main body in the direction
of the arrow, Fig.6, making sure not to
snag any of the cables.
ATTENTION: Make sure that the
tension control (77) functions correctly
by
anticlockwise.
15
turning
it
clockwise
and
Publicidad
