Makita DCU603 Manual De Instrucciones página 13

2. Insert the pipes of the handle into the dump unit as
shown in the figure, and then tighten 4 bolts securely.
Fig.9
► 1. Bolt 2. Handle
NOTE: When tightening the bolts, lift the handle
slightly.
3. Make sure that the dump unit is locked by pulling
down the handle.
Fig.10
► 1. Handle
4. Remove the cord cover located in the lower right
corner on the rear of the machine.
1
Fig.11
► 1. Cord cover
5.
the dump unit with two people as shown in the figure.
1
2
Fig.12
6.
machine. Tighten the rest of 4 bolts securely, and then
tighten 2 bolts at the rear of the machine securely.
1
1
Fig.13
► 1. Bolt (front) 2. Bolt (rear)
13 ENGLISH
Place the dump unit on the base unit by holding
Temporarily tighten 2 bolts at the rear of the
2