Solo 441 Manual Original página 6

Assembly carrying belt
 Thread the upper loop of the carrying belt (k),
through one of the three attachment ribs from
above depending on body size, so that the two
clamping sliders (s) are on the outside.
 Secure the loop with the attachment pin (m)
from below.
 Thread the ends of each carrying belt through
the specified slits in the standing base (e).
 Tighten the belt.
7.2 Length adjustment of the carrying straps
Fig. 5
Pulling down the two strap ends will tighten the
carrying straps.
ENGLISH 6
Fig. 6
Fig. 3
Pulling the two belt ends upwards will loosen the
carrying strap.
7.3 Filter, filling screen and intake screen
Fig. 2
Fig. 4
The nozzle assembly (i) includes a filter (q) insert
in front of the nozzle.
Fig. 7
The filter, filling screen and intake screen are
required when using the device.
The basket in the
filling neck (c) of
the liquid tank
contains a filter
screen(r).
Fig. 8
The intake screen is
pushed on at the intake
hose to the pump of the
spraying agent tank.