Publicidad
Idiomas disponibles
Idiomas disponibles
Getting Started
Rear Panel
2
Cooling fan
• The fan operates while the unit is
powered on.
If you set the unit to the minimum
1
volume, the fan won't operate.
Secure a minimum 6 inches (15 cm) of
clear space on from all sides of the fan
when installing the product.
POWER
2
• Insert only the provided power cable.
2.2 CH Speaker Terminals
1. To achieve the correct sound quality,
when you connect the speakers, match
the color of the speaker plugs to the
color of the speaker jacks. See below.
3
• LEFT channel (marked
• RIGHT channel (marked
• Don't force the Purple SUBWOOFER
connector into the White or Red speaker
jack.
LED Terminals for Speaker Beat
Waving.
4
ONLY FOR SERVICE
• This jack is for testing only. Please do
5
not use.
6
, White/Purple).
7
, Red/Purple).
8
8
English
1
3
4 5 678
AUX IN 2 Terminals
1. Use an Audio Cable (not supplied) to
connect AUX IN 2 on the product to
Audio Out on an external analog output
device.
• Be sure to match connector colors.
• If the external analog output device has
only one Audio Out jack, connect either
left or right.
• Press the TUNER/AUX button to select
AUX 2.
• If the product is in AUX mode for more
than eight hours and no buttons on the
front panel or remote are pushed, the
system will turn off.
AM Antenna Terminals
1. Plug the connector of the AM antenna
into the AM antenna connector terminal
on the rear of the product
FM Antenna Terminals
1. Connect the FM antenna to the FM
antenna connector terminal.
2. Slowly move the antenna wire until you find
a location where reception is good, then
fasten it to a wall or other rigid surface.
3. If reception is poor, you may need to
install an outdoor antenna. To do so,
connect an outdoor FM antenna to the
FM socket on the rear of the system
using a 75Ω coaxial cable (not supplied).
Publicidad
