Publicidad
Step 1
å
Assemble your unit on a carpeted floor or on the empty carton to
avoid scratching your unit or the floor.
å
Fasten the TOP/BOTTOMS (D) to one of the ENDS (B). Tighten
four 3-5/16" HEX HEAD SCREWS (3) using the L-WRENCH (4).
å
NOTE: You should start each SCREW a few turns before completely
tightening any of them.
D
Meet Parts (B and D). These components
have been engineered to be lighter,
stronger, faster... well ok. Not technically
faster. But definitely makes for a sturdier
2-Cube Organizer that' s easier to assemble
and friendlier to the environment.
430628 / 211-4705
4
D
www.sauder.com/service
3-5/16" HEX HEAD SCREW
(4 used in this step)
S u r
B
f a c
e w
i t h
m o
r e h
o l e
s
Some assembly
(and snacks) required.
3
Page 3
Publicidad
