BoomToneDJ ROBO WASH7X12W Manual De Instrucciones página 7

Restoring factory defaults
Press the "MODE/ESC" button and choose "LoAD"(load). Press "ENTER" to confirm. The LED display will change to
"d001" to confirm a factory reset has been completed
Initial start-up
During the warm up time, the unit will auto test itself for a few seconds. During this time the LED display will scroll
"rEST" from left to right .The unit then start to operate normally
f- DMX Modes
The unit supports 8 and 13 channel DMX Sub-modes from a standard controller. When a suitable DMX connection is
made, the "decimal point" in "d.001" will flash.
Setting DMX Addresses
Use the "MODE/ESC" button to display "d001", "UP" and "DOWN" buttons allows individual DMX addresses to be set
from "d001" to "d512"
Choosing between DMX Sub-modes
The LED display shows the chosen control mode when the "MODE" button is pressed. Use "UP" and "DOWN"
buttons to choose the appropriated DMX control Mode
LED Display
8CH
13CH
In 8 channel mode
Chan
Function
nel
1 PAN
2 TILT
3 DIMMER & STROBE
4 Red
5 Green
6 Blue
7 White
8 Pan/Tilt SPEED
MSC Distribution 2021
DMX Sub-mode
8Channel
13channel
13 DMX channel mode
Channe Function
1 PAN
2 PAN FINE
3 TILT
4 TILT FINE
5 PAN/TILT SPEED
6 DIMMER & STROBE
7 RED
8 GREEN
9 BLUE
10 WHITE
11 COLOR
12 COLOR SPEED
13 MOVEMENT (AUTO & SOUND CONTROL)
Page 7