Descargar Imprimir esta página

Ryobi R18PV-0 Traducción De Las Instrucciones Originales página 16

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
SAFETY WARNINGS FOR BLOWER
Wear a face filter mask in dusty conditions to reduce
the risk of injury associated with the inhalation of dust.
Do not point the blower nozzle in the direction of people
or pets.
Never place objects inside the nozzle or hose.
Do not operate the product near open windows.
Slightly dampen surfaces in dusty conditions.
Do not place the product on top of or near loose debris.
Debris may be sucked into intake vent resulting in
possible damage to the product.
Do not operate the product with defective guard,
enclosure or shields.
Always be sure of the footing on slopes and to walk,
never run.
Do not touch moving hazardous parts before the
product is disconnected from the power supply/battery
pack and the moving hazardous parts have come to a
complete stop.
Always wear substantial footwear and long trousers
while operating the product.
If the product is dropped, suffers heavy impact or
begins to vibrate abnormally, immediately stop the
product and inspect for damage or identify the cause of
the vibration. Any damage should be properly repaired
or replaced by an authorised service centre.
BATTERY AND CHARGER SAFETY
Connect and disconnect the battery pack properly.
To install battery pack:
Place the battery pack on the product.
Make sure the latches on each side of the
battery pack snap into place and the battery
pack is secured on the product before beginning
operation.
To remove battery pack:
Depress the latches on the side of the battery
pack.
Remove the battery pack from the product.
A battery operated product with integral batteries or a
separate battery pack must be recharged only with the
specified charger for the battery. A charger that may be
suitable for one type of battery may create a risk of fire
when used with another battery.
Do not expose charger to wet or damp conditions.
Do not place batteries near fire or heat. They may
explode.
Do not expose a battery pack or tool to fire or excessive
temperature. Exposure to fire or temperature above
130 °C may cause explosion.
Do not place product near any heat sources such as
radiators, heat registers, stoves, or other products
(including amplifiers) that produce heat.
Batteries can explode in the presence of a source
of ignition, such as a pilot light. To reduce the risk of
serious personal injury, never use any cordless product
in the presence of open flame. An exploded battery
can propel debris and chemicals. If exposed, flush with
2
| English
water immediately.
Battery products do not have to be plugged into an
electrical outlet; therefore, they are always in operating
condition. Be aware of possible hazards when not using
your battery product or when changing accessories.
Following the rule will reduce the risk of electric shock,
fire, or serious personal injury.
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Use of an attachment not recommended or sold by the
battery charger manufacturer may result in a risk of fire,
electric shock, or injuries to person.
When battery pack is not in use, keep it away from
other metal objects like paper clips, coins, keys, nails,
screws, or other small metal objects that can make a
connection from one terminal to another. Shorting the
battery terminals together may cause sparks, burns, or
a fire.
To reduce risk of damage to charger body and cord, pull
by charger plug rather than cord when disconnecting
charger.
For best results, your battery product should be
charged in a location where the temperature is more
than 10°C (50°F) but less than 38°C (100°F). To reduce
the risk of serious personal injury, do not store outside
or in vehicles.
Follow all charging instructions and do not charge the
battery pack or tool outside the temperature range
specified in the instructions. Charging improperly or at
temperatures outside the specified range may damage
the battery and increase the risk of fire.
Do not charge battery product in a damp or wet location.
Following the rule will reduce the risk of electric shock.
Make sure cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage and
stress.
Do not crush, drop or damage battery pack. Do not use
a battery pack or charger that has been dropped or
received a sharp blow. A damaged battery is subject to
explosion. Properly dispose of a dropped or damaged
battery immediately.
An extension cord should not be used unless absolutely
necessary. Use of improper extension cord could result
in a risk of fire and electric shock. If extension cord must
be used, make sure:
a) That pins on plug of extension cord are the same
number, size and shape as those of plug on
charger.
b) That extension cord is properly wired and in good
electrical condition.
Do not operate charger with a damaged cord or plug. If
damaged, have it replaced immediately by a qualified
serviceman.
Do not disassemble charger; take it to a qualified
serviceman when service or repair is required. Incorrect
reassembly may result in a risk of electric shock or fire.
Disconnect charger from power supply when not in use.
Risk of electric shock. Do not touch uninsulated portion
of output connector or uninsulated battery terminal.
Do not use a battery pack or tool that is damaged or
modified. Damaged or modified batteries may exhibit

Publicidad

loading

Este manual también es adecuado para:

R18pv