SET UP & USE
Step 5: Start the cycle
Press the START/PAUSE button to start the washing cycle. When the
washing cycle begins, the Estimated Time in minutes for the cycle to
complete will show and count down in the digital display. Or, if Delay Start
is set, the display will count down the hours until the cycle begins, and then
change to a minute countdown for the cycle.
CAUTION: When the washer is running, you should pause the program and wait
for the tub to stop completely before you open the lid.
Control Lock
RINSE & SPIN CYCLE GUIDE
Load Size
Program
Default
Normal
Large
Heavy
Large
Delicate
Large
Quick
Medium
Bulky
Large
Spin Only
–
Normal/Eco is the recommended wash cycle to wash up to a full load of normally
soiled cotton or linen clothing. The cycle (Normal/Eco on large load size and
cold water temperature) has a much longer spin time (86 minutes)than other
cycles, which removes more water from your clothes than other cycles, providing
you with energy savings when drying your clothes in your dryer.Hot and warm
water temperatures are the same when using Normal/Eco. If you need a higher
temperature wash, use a different program.
Press and hold the TEMP and PROGRAM buttons
simultaneously to activate this function. When Control Lock
is activated, the indicator light will turn on. The control panel
buttons will not function except for POWER and the ability to
deactivate Control Lock by pressing and holding the TEMP
and PROGRAM buttons again.
Soak
time
Scope
(approx.)
Sm, Med, Lg
–
Sm, Med, Lg
–
Sm, Med, Lg
–
Sm
–
Med
–
Lg
–
Sm, Med, Lg
15 min
–
–
Wash
Final
Time
Rinse
Spin
(ap-
Times
Time
prox.)
15 min
1
8 min
15 min
2
7 min
12 min
1
5 min
3 min
1
4 min
3 min
1
4 min
3 min
1
4 min
15 min
2
9 min
–
–
24 min
ENGLISH
Total
Time
34 min
52 min
35 min
15 min
19 min
22 min
69 min
26 min
Page 23