RIDGID R350CHD Manual Del Operador página 14

MAINTENANCE
REqUIRED DAILY CHECKLIST
See Figures 14 - 16.
 Disconnect the air supply from the tool and remove all
fasteners.
 Check all screws, nuts, bolts, and pins on the tool. If
any of these are loose, they must be tightened with the
appropriate size wrench.
 Make sure that the jam-clearing slide is securely in place
and the wing screw is tightened. Continue to check
the wing screw at regular intervals during each work
session.
 Press the workpiece contact against a workpiece to
ensure that it moves smoothly.
 With the workpiece contact depressed, pull the trigger.
The trigger should move smoothly, without binding.
 While the tool is not loaded, connect the appropriate air
supply (at 70 psi) to the tool.
 Rotate the selectable trigger knob on the trigger to Single
Sequential Actuation operation, Position A, as shown in
Figure 15. No air should leak from the tool.
• Without pulling the trigger, press the workpiece
contact against a workpiece several times. The tool
must not operate.
• With the workpiece contact not engaged on the
workpiece, point the tool down and away and pull
the trigger several times. Hold the trigger in this
position for a minimum of 5 seconds The tool must
not operate.
• Press the workpiece contact firmly against the
workpiece. The tool must operate.
• With the workpiece contact still depressed, release
the trigger. The driver must return to its up position.
 Rotate the selectable trigger knob on the trigger to
Contact Actuation operation, Position B, as shown in
Figure 16.
• With the workpiece contact not engaged on the
workpiece, point the tool down and away. Pull the
trigger. The tool must not operate.
• Keeping the trigger fully depressed, push the workpiece
contact against a workpiece. The tool must operate.
 If the tool successfully meets all the requirements in this
checklist, it is ready for use. Set the trigger on the tool
to operate in the manner that best fits your application.
Load the proper fasteners for the desired application.
 Set the depth of drive according to the "Drive Depth
Adjustment" section in this manual. Repeat this checklist
before using the tool each day, or if the tool is dropped
or damaged in any way.
14