Publicidad
Idiomas disponibles
Idiomas disponibles
12. After assembling the mantel, carefully lift
to the upright position. Push the fireplace
insert from the front of the mantel as
shown in Figure 39.
Figure 39
13. Drill two holes (5/16") in the corner where
the fireplace is to be displayed. Drill the
first hole 37
/
" from the ground up. Drill
7
8
the second hole 1
shown in Figure 40. Place 2) Wall Anchors
(CC) into holes by pinching the anchor tabs
together as shown in Figure 40.
CC
Figure 40
Continue with fireplace installation, returning to
200084-01A
MANTEL
Fireplace Insert
/
" from the first hole as
9
16
Mitered Corner Joints
1
/
"
9
16
37
41
Connecting to Gas Supply , page 13.
www.sureheat.com
14. Install the Set Square Support (H) to
the holes drilled in step 13, with 2) ST5
Screws 2
41. This block is used to support the Top
Triangle Panel (F). For thin walls, insert
white key (HH) into wall anchor and push
to "pop" open anchor wings.
HH
30
31
15. Push fireplace into the corner so that the
Top Triangle Panel (F) is resting on top of
the Set Square Support (H) as shown in
Figure 42.
/
"
7
/
"
1
8
2
/
" (EE) as shown in Figure
3
8
EE
/
"
/
"
3
1
4
2
Figure 41
Figure 42
Mitered
Corner
Joints
H
Baseboard
H
F
35
Publicidad
