Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION - Ventilation
1. Set the fan on a level surface, such as a table.
2. Tilt the fan to the required angle (see Figure 2). You can set the fan:
a. to blow horizontally or angled slightly downwards. First loosen the adjusting nut (3) a little bit. Turn
the ventilation basket and the motor casing vertically in the desired position (with an angle of 10°)
and fasten the adjusting nut.
b. to oscillate from left to right (with a sweep of 80°). Use the pivot button for this (1). This will
ventilate much of the room. Press the oscillation button in until you hear it click.
c. remain in the same position whilst the fan is turning. This will ventilate one area. Pull out the
oscillation button on the motor housing.
3. Put the plug into the wall socket.
4. Switch on the fan by turning the speed switch (2).
a. Position 'I': the fan operates at low speed.
b. Position 'II': the fan operates at normal speed.
c. Position 'III': the fan operates at high speed.
5. Stop the fan by turning the speed dial to position '0'.
6. Switch off the appliance after each use and remove the plug from the wall socket.
CLEANING AND MAINTENANCE
Over the course of time dust can accumulate between the spokes in the fan housing, and on the fan
blades. Always begin by trying to remove the dust with a brush and/or vacuum cleaner. If this does not
remove all the dust you can always dismantle the fan and clean it.
WARNING:
•
Verify that the appliance is not connected to the power supply before you clean it.
•
Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
Reassemble the fan using the procedure given under by 'Assembling'.
25
EN
Publicidad
