Publicidad
Idiomas disponibles
Idiomas disponibles
A. Press and hold the Electric Ignitor. Meanwhile, push and turn the Control Knob counter-clockwise to the "LOW"
position. Keep pushing the Control Knob to light the burner .
B. After ignition, release the Electric Ignitor. Continue to push and hold the Control Knob for 45 seconds.
C. If ignition does NOT immediately take place in seconds, push and turn the Control Knob clockwise to "OFF". Wait 5
minutes, then repeat the lighting procedure as above.
Caution: *If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could
accidently ignite with risk of injury.
TO EXTINGUISH
※ Push the Control Knob and turn clockwise to the "OFF" position.
※ Turn the cylinder valve on the gas tank clockwise to close the gas supply if not in use for a long time.(See below
figure)
ROUTINE CARE
※ Keep your fire table free and clear from combustible materials.
※ Visually inspect burner from obstructions, keep fire table free and clear from debris.
※ After the burner and lava rocks are completely cooled down, use a soft brush to get rid of the mild stains,
loose dirt and soil. Wipe with a soft cloth.
STUBBORN STAINS
※Stubborn stains, discoloration and possibly rust pitting can occur from exposure to harsh outdoor conditions.
※Be careful not let any powder or solvent come in contact with painted or plastic components as damage may occur.
MAINTENANCE
※Store the fire table in a cool dry place away from direct sunlight.
※The propane cylinder must be disconnected and removed from the fire table before the appliance can be stored
indoors.
※Make sure both the gas and the fire table are turned off before changing battery. Please refer to the process of
assembling battery.
※Use Manufacturer approved or supplied replacement parts and accessories only. Otherwise this will void the warranty
of this product and may result in a hazardous condition.
※Please contact the Manufacturer for information regarding replacement hoses thermocouples ignitors lava rocks etc.
Observe flame height when lit:
Flame should possibly be a yellow/blue color
between 2 to 10 inches high.
OFF
IGNITER-PUSH
HIGH
8
Publicidad
