DICSA PM18F-9J Manual De Uso página 13

TABLE OF CONTENTS
1
Introduction
2
Safety rules
3
Equipment
4
Start-up
5
Maintenance
6
Trouble shooting
CAUTION
Dies Sets Required to be installed Clockwise 1 2 3 4
5 6 7 8 if you look infront of the crimping machine.
Die number 1 could install to any master die, but the
folowing die number 2 should be beside the die number
1 and clockwise. Especially for the die number under
under 16 mm . This is important to keep the ferrule
crimped with good roundness.
13 | English