Publicidad
Idiomas disponibles
Idiomas disponibles
4
START-UP
MACHINE PLACEMENT
Place the machine on a stable and flat surface.
SELECTING DIES
Determine the crimping dimensions for the current operation and select
the die set with the correct interval that corresponds to the crimping
measurement. For example: A crimping measurement of 17mm requires the
die size nr 16 (since it covers the 16-19 mm interval).
Always select the die set within the correct interval to achieve the best
crimping results. Every die is marked
with the smallest crimping measurement in the interval.
Note!
Crimping any measurements outside the table crimping measurement
interval is not recommended. Using dies that are too small risk the ferrule
becoming oval.
P18 DIES
DIE SET
16-10
16-12
16-14
16-16
16-19
16-23
16-27
16-31
Base Die
18 | English
CRIMPING AREA
10-12mm
12-14mm
14-16mm
16-19mm
19-23mm
23-27mm
27-31mm
31-39mm
39-45mm
1. Die size marking
2. Die set pin
Publicidad
