Publicidad
Idiomas disponibles
Idiomas disponibles
CHANGING DIE SETS
1. Retract the dies completely by turning the return valve one turn.
2. Remove the die set by turning it is either direction or pulling it straight
out (redially).
3. Ensure that the 8-segment die set is clean, undamaged and that all are
marked with the same number.
4. With the die marking numbers facing you, insert each die clicking the die
pins in their holes in the crimping head.
5. Ensure that all dies are correctly inserted in the machine.
CRIMPING
1. When the die set is inserted in the machine and the crimping
measurement set, place the hose/pipe application between the dies. Ensure
that all dies are correctly inserted in the machine.
2. The crimping diameter is reached when the light in red become light.
3. Make sure that the crimping was correct and make adjustments if
necessary.
20 | English
Publicidad
