STOK QUATTRO SGP4130N Manual Del Propietário página 11

LEFT
SIDE
PANEL
REAR
PANEL
BRACE
BOLT
(MM)
SLOT
Fig. 6
STEP 2: ASSEMBLING SIDE PANELS TO THE
BASE
See Figure 6.
 Slide the tabs into the slots then sit the panel on the base
aligning the holes in the tabs at the bottom of the right
side panel with holes on the left side of the base.
 Slide bolts, M5 x 12 mm (MM) three per side, through
both the tab and into the base. Tighten securely.
 Repeat above steps to install the left side panel.
STEP 3: ASSEMBLING BRACES AND REAR
PANEL
See Figures 6 - 7.
Installing the rear panel:
 Place bolts, M5 x 12 mm (MM), through the side of the rear
panel and into the side panel. Tighten securely. Repeat
for the other side.
ASSEMBLY
RIGHT SIDE
PANEL
TAB
TAB
FRONT
PANEL
Fig. 7
Installing the braces:
 Secure two braces to the base and side panels using
M5 x 12 mm bolts (MM). Tighten securely.
 Secure the remaining two braces to the side and rear
panels using M5 x 12 mm bolts (MM). Tighten securely.
Installing the front panel:
 From the front of the base, align the holes in the front
panel with the holes at the top of the side panels.
 Secure the front panel to the side panels using four bolts,
M5 x 12 mm (MM).
BASE
Fig. 8
11
BOLT
(MM)
INSERT
STORAGE