STOK QUATTRO SGP4130N Manual Del Propietário página 12

STEP 4: ATTACHING INSERT STORAGE TO
BASE
See Figure 8.
 Insert the wire frame for insert storage into the holes
inside the cabinet.
 Add additional storage brackets as needed.
STEP 5: MOUNTING THE FIREBOX TO THE
CABINET
See Figure 9.
NOTE: This step requires two people to lift and correctly
position the grill assembly on the cabinet.
 Lower the firebox assembly onto the cabinet, aligning
the holes in the firebox with the holes in the cabinet.
NOTE: Regulator hose should be hanging down inside
the cabinet; be careful not to damage.
 Using four bolts, M5 x 12 mm (MM) one in each corner,
secure the firebox assembly to the cabinet.
BOLT
(MM)
FIREBOX
ASSEMBLY
Fig. 9
ASSEMBLY
STEP 6: INSTALLING THE HOOD ONTO THE
FIREBOX
See Figure 10.
 To install the temperature gauge, remove the hex nut,
 Insert the large threaded post through the large hole in
 Install the washer, lock washer, and hex nut onto the post.
WASHER
REGULATOR
HOSE
Fig. 10
12
lock washer and washer.
the hood and insert the small post into the small hole in
the hood.
Securely tighten.
TEMPERATURE GAUGE (A3)
THREADED
POST
SMALL
HOLE
LARGE
HOLE
NUT
LOCK WASHER
HOOD
NUT (FF)
LOCK WASHER
(HH)
WASHER
(GG)
HOOD
BOLT (II)
SMALL
POST
GRILL
HOOD
HOOD