Charging The Rechargeable Battery; Inserting The Battery - Carrera RC Blue Scorpion Instrucciones De Montaje Y De Servicio

Charging the rechargeable battery

1
2
RED = Charging GREEn = Ready
Always recharge the battery immediately after use to prevent its becoming deep
discharged. Recharge the battery occasionally (suggested every 2­3 months).
Failure to treat the battery as described above can lead to its becoming defective.
Rechargeable batteries are only to be charged by adults.
Installing the rechargeable battery
1
2
First connect the Carrera RC rechargeable
battery to the battery charger supplied. The
connection terminals between the battery
and the charger are designed to prevent
connection with the wrong polarity. Connect
the charger to a power source.
When the battery is properly connected and
charging normally, the red LED is constantly
lit. Once the battery is fully charged, the red
LED switches to green. The battery can now
be disconnected and installed in the Carrera
RC car.
The car is now ready for use.
After use, the battery must be allowed to cool
down for at least 20 minutes before it can be
fully recharged. Failure to observe this
pause may damage the battery.
Using a screwdriver, remove the cover of the
battery compartment in the Carrera RC car.
Connect the end of the cable from the
Carrera RC vehicle with the charged battery.
Put the battery in place.
Replace the compartment cover using
a screwdriver.

Inserting the battery

1
2
ALKALINE
Now you can drive the car
1
2
10
Press the release button, then take the
battery compartment out of the control-
ler.
Take care when inserting the batteries
that the polarity is correct. Different
types of batteries or new and used bat-
teries are not to be mixed. Push the
battery compartment back into the con-
ALKALINE
troller until it clicks into place.
When the control LED flashes, the 2AA
batteries in the controller must be
replaced.
The Carrera RC vehicle and the control-
ler are connected with each other at the
factory. Should there be any communi-
cation problems at the start between
the Carrera RC vehicle and the control-
ler, please carry out a reconnection.
Switch the car on. Press the "Binding"
button on the back of the controller and
hold it down while switching on.
The LED on the controller begins to
flash. After a few seconds if binding is
successful, the LEDs on the car and the
controller will light again continuously.