Charging The Rechargeable Battery; Controller Functions - Carrera RC Racing Machine 120007 Instrucciones De Montaje

Charging the rechargeable battery

1
2
RED = Charging GREEN = Ready
Installing the rechargeable battery
1
2
Fitting in the batteries
1
2
First connect the Carrera RC rechargeable
battery to the battery charger supplied. The
connection terminals between the battery
and the charger are designed to prevent
connection with the wrong polarity. Connect
the charger to a power source.
When the battery is properly connected and
charging normally, the red LED is constantly
lit. Once the battery is fully charged, the red
LED switches to green. The battery can now
be disconnected and installed in the Carrera
RC car.
The car is now ready for use.
Using a screwdriver, remove the cover of the
battery compartment in the Carrera RC car.
Connect the end of the cable from the
Carrera RC vehicle with the charged battery.
Put the battery in place.
Replace the compartment cover using
a screwdriver.
Press the release button, then take the
battery compartment out of the controller.
Take care when inserting the batteries that
the polarity is correct. Push the battery
compartment back into the controller until
it clicks into place.
Now you can drive the car
1
2
Let's practise!
1
• Avoid constant motor operation.
• After use, remove or disconnect the battery.
• Clean the Carrera RC car after use.

Controller functions

1
ON
OFF
2
10
The Carrera RC vehicle and the control-
ler are connected with each other at the
factory. Should there be any communi-
cation problems at the start between
the Carrera RC vehicle and the control-
ler, please carry out a reconnection.
The reconnection is carried out by
pressing the connection button on the
underside of the RC vehicle chassis.
The connection button must remain
pressed for at least three seconds.
Please note that the controller must be
switched on when reconnection is made.
Switch on the Carrera RC car using the
ON/OFF switch.
Now it's time to practise!
Set up a Carrera RC vehicle racing
track in a large empty area, using
cornerposts, empty cans, or similar
objects. The basic technique to adopt
when operating a Carrera RC is to drive
fast on the straight sections and to slow
down in the curves.
When the controller is switched on,
the red LED lamps at the front of the
controller are lit.
Steering digital proportional
Gas pedal to the rear: forwards
Gas pedal to the front: braking,
or backwards