Publicidad
Idiomas disponibles
Idiomas disponibles
• Fill out all FTP server data. The port is usually set to 21.
• Set the FTP mode to standard (PORT) or passive (PASV).
• When desired, check the 'Upload Image Now' checkbox and set an upload interval (in seconds).
• Press 'Submit' to store the data before performing an 'FTP test'. A successful test will display 'FTP
test succeeded'. Possible error messages are:
• Can not connect to server.
Check FTP server address
• Network error. Please try later.
Check network cabling and settings.
• Server error.
Check the FTP server
• Incorrect user or password.
Make sure to enter the right user name and password.
• Can not access the folder.
Make sure the folder exists and your FTP account is authorized.
• Error in PASV mode.
Make sure the server supports PASV mode.
• Error in PORT mode.
If the device is behind a NAT (Network Address Translation) device, PASV mode must
be selected.
• Can not upload file.
Make sure your FTP account is authorized.
Alarm Service Settings
• Check the 'Motion Detect Armed' checkbox to enable motion detection. This also allows mails to
be sent out (see Mail Service Settings) and image upload to an FTP server (see FTP Service
Settings).
Note: when the camera is in auto tilt/auto pan mode (see For Operator layout), motion
detection and external alarm input are disabled!
• The motion detect sensibility van be set between 1 and 10, with 10 being most sensitive.
• Check the 'Send Mail on alarm' checkbox to send a mail when an alarm is detected. Make sure to
fill out all fields on the 'Mail Service Settings' page (see above).
13.12.2010
CAMIP5N
14
©Velleman nv
Publicidad
