Velleman CAMIP5N Manual Del Usuario página 6

o Cameras are found and listed (see image below).
o Cameras are found but are not on the same subnet as the PC. The message 'Subnet doesn't
match, dbclick to change' appears. Change the subnet settings via the network configuration
menu (see further).
Note: make sure DHCP is enabled in the router and MAC address filter is disabled. When
problems remain, disable any active firewall or antivirus and try again.
Windows:
Mac:
• Open the options menu by right clicking on a listed camera.
Note: only when the camera is fully initialised all options become visible.
Basic properties
• Shown some general information about the camera:
Network Configuration
• View/change the network settings of the camera:
13.12.2010
CAMIP5N
6
©Velleman nv