Publicidad
Idiomas disponibles
Idiomas disponibles
Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Install the safety bond by inserting the quick link in the hole on the bottom of the base Pull the safety bond
over the trussing system etc. Insert the end in the quick link and tighten the fixation screw.
The maximum drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
Installation via the adapter plate
Screw both clamps via a M12 screw and nut onto the respective holes in the adapter plate.
The clamps may either be installed horizontally or vertically.
Insert the four quick-lock fasteners of the adapter plate into the respective holes on the bottom of the device.
Tighten the quick-lock fasteners fully clockwise.
39/104
00026934.DOC, Version 1.6
Publicidad
