Publicidad
Idiomas disponibles
Idiomas disponibles
Observe all local plumbing codes.
„
Make sure the water supply is shut off.
„
Read these instructions carefully to ensure proper installation.
„
TOTO reserves the right to update product design without notice.
„
Gasket / Sieve
Showerhead
Assembly
NO TE:
• Thoroughly clean and remove debris from the water supply pipe be-
fore installation to prevent clogging the spray outlet.
• After water is shut off, showerhead will leak the remaining water from
the air intake hole until cleared (approximately 30 seconds).
• Do NOT twist showerhead to install shower arm.
1. Slide escutcheon onto the shower arm.
2. Wrap the shower arm threads with pipe tape. Screw the shower arm into
the supply elbow.
3. Ensure the gasket/sieve is in the pivot ball before installation.
4. Thread the showerhead onto the shower arm by hand. Twist the
showerhead until the TOTO logo is positioned to read correctly left to
right and parallel to the ground.
CAUTION: If TOTO logo is not positioned parallel to the ground,
leakage may result.
5. Use an adjustable wrench to tighten the showerhead to the shower arm
firmly enough to seat the gasket and prevent leaking.
BEFORE INSTALLATION
INSTALLATION PROCEDURE
Finished wall
Escutcheon
Shower Arm
Pipe Tape
3
Publicidad
