To sterilize pacifiers:
1. Place the bottle warmer on a stable surface, out of reach of
children.
2. Pour of water into the bottle warmer. (see the short marking mark)
3. Put the pacifiers you'd like to sterilize down into the bottle warmer.
4. Place the steam cover onto the bottle
heat inside and to prevent hot splashes from harming you.
KEEP IN MIND THAT THIS STEAM COVER
MAY BECOME VERY HOT DURING USE.
5. Insert the plug into a 230Volts wall socket.
6. Press the
button to switch on the bottle warmer.
7. Now within 5 seconds, use the M button to select the option
8. 5 seconds after making your selection the heating
element of the bottle warmer will switch on while
the display starts counting down to 0. During the
sterilizing process, the
9. After the 5 minutes sterilizing time (or longer, the
sterilizing lasts untill all the water is evapora-
ted), 5 beeps are emitted and the bottle warmer
switches itself off.
10. Attention: the steam cover may become very hot. First wait several minutes
until the temperature has decreased sufficiently for you to safely remove the
steam cover. Use kitchen pliers (not included) to remove the pacifiers from
the bottle warmer.
Cleaning:
Disconnect the Baby Bottle Warmer from the mains socket (or the cigarette
lighter socket) and allow it to cool down. Clean the container and the outside
of the Baby Bottle Warmer with a damp cloth. Never immerse the Baby
Bottle Warmer in water. Do not use cleaning orscouring agents.
Decalcify:
Hard water deposits must be removed. To do this use white vinegar only.
Pour the vinegar into the tank at mid-level, allow to rest until the hard water
deposits have been completely eliminated. Rinse well and wipe with a damp
cloth.
Warning:
If a fault occurs, consult the Alecto service centre at WWW.ALECTO.NL
Under no circumstances should you try to repair the Baby Bottle Warmer
yourself; do not dismantle. Servicing should be performed by qualified
service personnel only.
display icon will rotate.
MAINTENANCE INSTRUCTIONS
19
warmer to both keep the