Publicidad
Idiomas disponibles
Idiomas disponibles
> Before Start
> Part Names
Setup Menu
Setup
1
> Install
> Playback
The unit allows you to configure advanced settings to provide you with an even better
experience.
1. Press SETUP (b) on the remote controller.
2. Select the item with the Up/Down buttons (a) on the remote controller and press ENTER
(d) to confirm your selection.
3. Select the submenu with the Up/Down buttons (a) on the remote controller.
4. Select the setting value with the Left/Right buttons (c) on the remote controller and press
ENTER (d) to confirm your selection.
0 To return to the previous display, press RETURN (e).
5. To exit the settings, press SETUP (b).
a
b
AutoStandby
This setting places the unit on standby automatically after 20 minutes of inactivity without
any audio input.
"On": The unit will automatically enter standby mode. "ASb" lights on the display.
"Off": The unit will not automatically enter standby mode.
0 "AutoStandby" is displayed on the display 30 seconds before the Auto Standby comes on.
0 Default values vary depending on the regions.
Digital Input
You can change input assignment between the input selectors and DIGITAL IN COAXIAL/
Setup
AutoStandby
c
d
e
| Others
En
21
Publicidad
