Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
(Continued)
• Save all instructions
B
Assembly Instructions
The tiller comes fully assembled except for a few parts. The following instructions will help you complete the tiller assembly.
INSTALL THE WHEELS
(See Figure 2)
1. Slide the wheel hub onto the wheel axle.
2. Install M8 x 20mm bolt with 30 mm flat washer.
Saddle Bolts
Handle Knobs
ATTACH UPPER HANDLE
1. Slide the upper handle down over the lower handle and
align the holes.
2. Insert the saddle bolts into the holes as shown and
securely with the handle knobs.
3. Tighten the handle knobs securely.
Questions? Call Toll Free at 1-800-737-2112
Figure 2
Saddle Bolts
Handle Knobs
Figure 3
(See Figure 3)
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
INSTALL THE DRAG BAR
1. Remove the bolt and knob from the depth regulator lever.
2. Insert the drag bar into the bottom of the swing plate
bracket.
3. Insert the detent pin thru the bracket and drag bar.
8
Copyright © 2011 MAT Engine Technologies, LLC
Figure 4a
Figure 4b
(See Figure 4a and 4b)
Publicidad
