Publicidad
Idiomas disponibles
Idiomas disponibles
5.2 Start-up
OMNITRONIC
OMNITRONIC
Transmitter
Transmitter
T
M-100
T
M-100
Screw the microphone lead into the microphone input socket.
Screw the antenna into the antenna socket.
Attach the pocket transmitter via the belt clip to the belt or waistband.
With the operation selector, you can switch the device on and off. When switching the device on, the red
LED shortly lights up. In this case, the power supply is sufficient.
When the battery is getting weaker, the red LED is permanently illuminated. In this case, the batteries have
to be replaced.
If the red LED does not light up when switching on, there is either no battery inserted or the poles are wrong.
Please note that the operation selector has to be set to ON in order to transmit microphone signals.
Via the Mic Adj. control in the battery compartment, you can adjust the microphone sensitivity. Use a screw-
driver in order to turn the control until the desired sensitivity is adjusted.
If the microphone is not used, switch the transmitter off via the operation selector. If the presentation etc. is
over choose OFF. If the device will not be used for a longer period of time, remove the battery in order to
avoid battery leakage.
6. CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the battery. Maintenance and service operations
are only to be carried out by authorized dealers.
In order to replace the battery please refer to "Inserting/exchanging batteries".
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.
11
Publicidad
