Ryobi AP1305 Manual Del Operador página 10

TOOLS NEEDED
See Figure 4, page 20.
The following tools (not included or drawn to scale) are
needed for assembly and maintenance:
 Framing Square
LOOSE PARTS LIST
See Figure 5, page 20.
The following items are included with the tool:
Key
No. Description
A Blade wrench .......................................................1
B Switch key ...........................................................1
C Depth adjustment crank handle ..........................1
D Lock washer ........................................................1
E Hex socket screw ................................................1
F Magnets ...............................................................2
Operator's Manual (not shown) ...........................1
UNPACKING
This product requires assembly.
NOTE: Every RYOBI Thickness Planer is tested at the fac-
®
tory to ensure its performance. You may see small amounts
of wood dust and chips on your new planer.
 Carefully lift the tool from the carton and place it on a
level work surface.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
WARNING:
Do not use this product if any parts on the Loose Parts
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 The saw is factory set for accurate cutting. After assem-
bling it, check for accuracy. If shipping has influenced the
settings, take to an authorized service center.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
ASSEMBLY
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
Qty.
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious personal injury.
MOUNTING THE PLANER TO WORKBENCH
If your planer is to be used in a permanent location, it is
recommended you secure it to a workbench or other stable
surface. When mounting the planer to a workbench, holes
should be drilled through the supporting surface of the
workbench.
 Mark holes on workbench where planer is to be mounted
using holes in planer base as a template for hole pattern.
 Drill four holes through workbench.
 Place planer on workbench aligning holes in the planer
base with holes drilled in the workbench.
 Insert four bolts (not included) and tighten securely with
lock washers and hex nuts (not included).
NOTE: All bolts should be inserted from the top. Install
the lock washers and hex nuts from the underside of the
workbench.
Supporting surface where planer is mounted should be
examined carefully after mounting to insure that no move-
ment during use can result. If any tipping or walking is noted,
secure workbench or support surface before beginning
planing operation.
Page 10 — English