Publicidad
Idiomas disponibles
Idiomas disponibles
Roll Adjustment
Adapter plate may be rolled +/- 5°. Roll locking screw may be tightened or loosened using 4 mm allen wrench (G).
4
NOTE: Do not remove roll locking screw.
CAUTION
• Do not tighten joint screws. Doing so may cause
damage to screws, greatly reducing their holding
power.
Cable Management
Cables may be routed using cable clip (I).
5
Slip cable clip (I) onto bottom of center joint as shown in fi gure 5.1 and secure cables to cable clip using cable tie
(J) as shown in fi gure 5.2.
Secure cables to cable clip (I) using cable tie (J) as shown below.
I
fi g. 5.1
CENTER
JOINT
ROLL LOCKING SCREW
J
CABLES
fi g. 5.2
10 of 32
ISSUED: 10-24-11 SHEET #: 095-9365-2 12-14-11
All other brand and product names are trademarks or registered trademarks of their respective owners.
JOINT SCREWS
WALL PLATE
SLOTS
J
CABLES
© 2011, Peerless Industries, Inc. All rights reserved.
Peerless Industries, Inc.
2300 White Oak Circle
Aurora, Il 60502
www.peerlessmounts.com
Publicidad
