Publicidad
Idiomas disponibles
Idiomas disponibles
Installation to Solid Concrete or Cinder Block
• When installing Peerless wall mounts on cinder block, verify that you have a minimum of 1-3/8" (35 mm) of actual
concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount
in a solid part of the block, generally 1" (25 mm) minimum from the side of the block. Cinder block must meet ASTM
C-90 specifi cations. It is suggested that a standard electric drill on slow setting is used to drill the hole instead of a
hammer drill to avoid breaking out the back of the hole when entering a void or cavity.
• Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
NOTE: Wall arm assembly (A) must be mounted to
1
wall using inner mounting holes.
Make sure that wall arm assembly is level and use
wall plate as a template to mark four mounting
holes. The top mounting slots should be located
6.17" (157 mm) above the desired display center
as shown in fi gure 1.1 on page 4. Drill four 5/16" (8
mm) dia. holes to a minimum depth of 2.5"
(64 mm). Insert anchors (D) in holes fl ush with wall
as shown. Place wall arm assembly over anchors
and secure with wood screws (C). Level, then
tighten all fasteners. Insert eight fastener caps
(H) into mounting holes. NOTE: Be sure arrow is
pointing up when mounting wall arm assembly (A)
to wall as shown in fi gure 1.1.
WARNING
• Tighten screws so that wall plate is fi rmly attached,
but do not overtighten. Overtightening can damage
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Always attach concrete expansion anchors directly
to load-bearing concrete.
• Never attach concrete expansion anchors to
concrete covered with plaster, drywall, or other
fi nishing material. If mounting to concrete surfaces
covered with a fi nishing surface is unavoidable,
the fi nishing surface must be counterbored as
shown below. Be sure concrete anchors do not
pull away from concrete when tightening screws. If
plaster/drywall is thicker than 5/8" (16 mm), custom
fasteners must be supplied by installer.
INCORRECT
wall
plate
plaster/
dry wall
concrete
wall
plate
plaster/
dry wall
WARNING
1
Drill holes and insert anchors (D).
2
Place plate (A) over anchors (D) and secure with screws (C).
3
Tighten all fasteners.
H
CORRECT
concrete
5 of 32
F
A
C
SOLID CONCRETE
D
C
A
ISSUED: 10-24-11 SHEET #: 095-9365-2 12-14-11
concrete
surface
D
D
CINDER
BLOCK
Publicidad
