Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting and Removing Flat Panel Display
• Always use an assistant or mechanical lifting equipment to safely lift and position the fl at panel displays.
• Be careful not to pinch fi ngers when opening and closing mount from the wall.
• DO NOT operate or tilt arm assembly when safety latches are in unlocked position. Product may fail and may cause
injury or damage to display.
• Do not tighten safety/security screw (E) with excessive force. Overtightening can cause screw head to become
damaged making it diffi cult to remove. Tighten screws to 15 in•lb (1.7 N.M.) maximum torque.
Wall arm assembly (A) must be in closed position to
3
hang display.
Rotate safety latch with fl athead screwdriver into
unlocked position as shown in detail 1.
DETAIL 1
Hook adapter brackets (B) onto the center of wall
arm assembly (A) adapter plate as shown in fi gure
3.1.
SAFETY LATCH
B
A
fi g. 3.1
WARNING
Rotate safety latch with fl athead screwdriver and
install safety/security screw (E) through safety latch
into adapter bracket with phillips screwdriver to lock
to adapter plate as shown in detail 2 and detail 3.
9 of 32
B
DETAIL 2
SAFETY
DETAIL 3
LATCH
ISSUED: 10-24-11 SHEET #: 095-9365-2 12-14-11
A
E
Publicidad
