Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Remove the corresponding fasteners from the rubber trim piece. This is necesary in order for the hood shield flanges to slide under the
rubber trim piece. NOTE: It may be necessary to remove additional fasteners in order to accomodate the flange, depending on size.
3
Position the hood shield with the flanges sliding between the hood
and rubber seal. Align holes.
4
Insert (6) screws through rubber trim and into recep-
tacles and apply pressure while tightening screw to
6
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Lund
and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in terms of
fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
secure to hood.
hood shield
receptacle
screw
®
branded products offered by Lund International, Inc. We take the utmost pride in our products
800-241-7219 • Visit us at lundinternational.com
© 2016 Lund International, Inc. All rights reserved.
Lund
and the Lund
logo are trademarks of Lund International, Inc.
®
®
Insert (6) receptacles UNDER rubber trim and through
5
Lower hood, adjust hood bumper stops to ensure
hood shield clears grille and headlights. Install bump
ons at pre-cleaned locations on the painted hood/
rubber
trim
7
Lund International
Page 2 of 2
front edge of
fastener
rubber trim
hood shield, and then into hood.
receptacle
fender surface.
hood
hood shield
rubber trim
Publicidad
