LUND Elite Serie Instrucciones De Instalación

For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Important Safety Information
• CAUTION - Before driving, ensure that the fender flare is properly secured to vehicle.
• Do not use automatic "brush-style" car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.
Contents
NOTE: (Content shown below is for (4) piece installations. (2) Piece installations will contain smaller quantities.)
Driver side front
Driver side rear
Tools Required
Preparation Before Painting / Installation
Custom Paint Job (Optional)
Please test fit all the flares first to ensure you have the correct flares for your vehicle. We are not responsible for any costs you may incur if you did not confirm the flares
before having it painted. We recommend hiring professionals to custom paint the products. It is also ideal to have the painting done prior to the installation to eliminate any
over-spraying issues.
Remove existing fender flares. (Skip this step if you don't have existing fender flares.)
Remove all the screws and fasteners currently holding the existing flare to the vehicle. Write down and save all the screws you have removed for re-use with the Lund fender flares.
If certain areas of the existing flares are held on with double sided tape, you will have to pry your existing flare off. Please do so carefully to avoid damage to your vehicle body.
Test fitting.
Hold each and every flare up to the fender. Make sure you align the flare to the contour of the body, and the mounting holes lineup to the existing mounting holes on the inner
fender lip (if applicable). Don't worry if not all the holes line up, as some holes are meant to be used with different installation hardware that is provided. The flares may not
be sitting flush at this time, our flares are designed to flex into the bodyline when you actually install them using the provided and existing hardware. At any time, do not drill
or modify the fender flare in anyway, as you will void your warranty.
Remove other existing parts.
Some vehicles may require the removal of existing parts that will interfere with the installation. Common item would be mud flaps; however by using fender flares, they act
as another form of mud deflector. If you are not confident in doing so, this will be a good time to take your vehicle to a professional for the installation. Save existing screws
and fasteners from the vehicle.
Cleaning the vehicle.
Make sure to wash your vehicle, especially the area the fender flares will be mounted to including the inner fender lip. Any dirt or debris that has not been cleaned or removed
can potentially cause the improper fitment of the fender flare. If you are covering existing rust, we recommend sanding down the rust and primer over to prevent further
deterioration of the metal in the fender. Make sure the vehicle is dry before the installation. The fender flares come ready to be installed, however if you need to clean them,
please use a mild detergent to wash and then dry completely.
Installation Instructions
Elite Series Fender Flares
Passenger side front Rubber Seal
Passenger side rear Offset Lever Clip x6
Razor Blade Hex Key 4.0 and 4.5
(RX Style only)
Rivet + Nylon Nut
x32
Socket Wrench
Page 1 of 3
I - Sheet Number I310-312 Rev.B
U-Clip x16 Push-In Clip
Phillips screwdriver
x2