Publicidad
Idiomas disponibles
Idiomas disponibles
USE
following controls luminous:
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III
F = AUTOMATIC STOP TIMER - 15 minutes (*)
If your appliance does not have the
INTENSIVE speed function, press key E
for two seconds and it will be activated for
10 minutes after which it will return to the
previously set speed. When the function is
active the LED flashes. To interrupt it before
the 10 minutes have expired press key E again.
By pressing key F for two seconds (with the hood switched off ) the "clean air" function
is activated. This function switches the appliance on for ten minutes every hour at the
first speed. As soon as this function is activated the motor starts up at the first speed for
ten minutes. During this time key F and key C must flash at the same time.
After ten minutes the motor switches off and the LED of key F remains switched on with
a fixed light until the motor starts up again at the first speed after fifty minutes and keys
F and C start to flash again for ten minutes and so on.
By pressing any key for the exclusion of the hood light the hood will return immediately
to its normal functioning (e.g. if key D is pressed the "clean air" function is deactivated
and the motor moves to the 2nd speed straight away. By pressing key B the function is
deactivated).
(*) The "automatic stop timer" delays stopping of the hood, which will continue func-
tioning for 15 minutes at the operating speed set at the time this function is activated.
- When button A flashes at a frequency of 2 seconds, the grease filters must be cleaned.
After the clean filter has been replaced, the electronic memory must be reset by pressing
button A for approximately 5 seconds, until the light on the button stops flashing.
A
B
- 19 -
C
D
E
F
Publicidad
