Helpful Tips; Maintenance; General Maintenance - Ryobi PSD101 Manual Del Operador

Lijadora de banda de 18 v 1/2 pulg. x 18 pulg.
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PROPER HAND PLACEMENT
See Figure 7, page 11.
For ease of operation and maintaining proper control, the
sander has a single rear handle. When operating the sander,
always hold the handle securely with your right or left hand.
WARNING:
Keep hands and fingers clear of moving sanding belt,
front idler roller, and drive roller assembly. Failure to do
so will result in serious personal injury.
WARNING:
Do not let your fingers rest over the front or right edge
of the sander. If the sanding belt should run off, or if it is
not properly adjusted, your fingers could come in con-
tact with the moving sanding belt, resulting in possible
serious injury.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
OPERATION

MAINTENANCE

NOTE: ILLUSTRATIONS BEGIN ON PAGE 10
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.

HELPFUL TIPS

 If the sanding belt slips or does not track while sanding,
you may be applying too much pressure. When this oc-
curs, remove the sander from the workpiece. If you prop-
erly adjust the belt tracking, the sanding belt will return
to its normal and correct position on the drive roller and
front roller.
 Use a coarser sanding belt for heavy sanding, not heavy
pressure. The weight of the tool is sufficient to provide
adequate pressure at the correct location.
 The front roller of the sander is not designed for contour
sanding. Sanding on the front roller could cause irregular-
ity in the sanding belt tracking.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
9 — English

Publicidad

Tabla de contenido
loading

Tabla de contenido