Notes
• Do not affix Velcro tapes to the name plate or any
control.
• When you are going to park your car for a long
period of time, remove the CD player from the
console box and place it where it will not be
exposed to direct sunlight.
Note on the car battery cord
The 4.5V DC plug supplied with car battery cord
conforms to the proposed standards of the Japan
Electronics and Information Technology Industries
Association (JEITA). Do not connect it to other
players.
Polarity of the plug
(JEITA standards)
Replacing the fuse of
the car battery cord
If the CD player does not operate, check the
fuse. If it is blown, replace it as follows:
1
Turn off the CD player and remove
the cigarette lighter plug from the
cigarette lighter socket.
2
Remove the plug end by turning it
counterclockwise.
3
Remove the defective fuse from
the plug.
4
Insert a new fuse into the plug.
5
Replace the plug end by turning it
clockwise.
Fuse
Remove
Plug end
Cigarette lighter plug
Notes
• Be sure to use a fuse of the same amperage and
length as the one to be replaced. Never use a
piece of wire as a substitute for the fuse.
• If the fuse is blown again after replacing it,
contact your nearest Sony dealer. In such a case,
bring the defective fuse to the dealer with you.
Notes on the car connecting pack
• If no sound is heard or the car connecting pack is
ejected, change the direction of playback on the
car cassette deck.
• Never insert the cord end of the car connecting
pack into the cassette insertion door. Otherwise,
the cord may break or the car cassette deck may
be damaged.
• You cannot use the car connecting pack with
some car cassette deck.
• The cord should be placed so that it does not
hinder driving.
• To disconnect the cord from the CD player, pull it
out by grasping the plug. Never pull the plug out
by the cord.
• With some car cassette decks, you may hear some
rattling noise from the car connecting pack.
However, this is not a sign of malfunction.
25
-GB