Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Symptom
Remedy
The connected Bluetooth
• Check whether the connected Bluetooth audio player
audio player cannot be
supports Audio/Video Remote Control Profile (AVRCP).
controlled.
(Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
"PLEASE WAIT"
The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the unit,
then connect the device again.
"NOT SUPPORT"
The connected phone does not support Voice Recognition
feature or phonebook transfer.
"NO ENTRY"
There is no registered device connected/found via
Bluetooth.
"ERROR"
Try the operation again. If "ERROR" appears again, check if
the device supports the function you have tried.
"NO INFO"/"NO DATA"
Bluetooth device cannot get the contact information.
"H/W ERROR"
Reset the unit and try the operation again. If "H/W ERROR"
appears again, consult your nearest service center.
"SWITCHING NG"
The connected phones might not support phone switching
feature.
The Bluetooth connection
Delete the unused registered Bluetooth device from the
between the Bluetooth
unit. (Page 21)
device and the unit is
unstable.
If you have any troubles, try the following:
1
Check TROUBLESHOOTING
2
Reset the unit (page 4)
3
Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: <https://www.jvc.com>
38
ENGLISH
Installation/Connection
This section is for the professional installer.
For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer.
WARNING
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
• To prevent short circuit:
– Insulate unconnected wires with vinyl tape.
– Be sure to ground this unit to the car's chassis again after installation.
– Secure the wires with cable clamps and wrap vinyl tape around the wires that come in contact
with metal parts to protect the wires.
CAUTION
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the
wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
• Connect speakers with a maximum power of more than 50 W. If the maximum power of the
speakers is lower than 50 W, change the [AMP GAIN] setting to avoid damaging the speakers.
(Page 25)
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned on
and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old
fuse with one that has the same rating.
Publicidad
