Stiga T8622 Manual Del Propietário página 2

For aid in identifying hardware, see hardware identifier on pg 13.
1. Lay table top #1 painted side down, on a smooth, flat
surface. Use the shipping container to protect the
painted surface of the table top.
2. Align U-Support (#7) on Table Top as shown in
Figure 1.
CAUTION:
WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT THE U-CLIPS
(#3) BE TURNED AS SHOWN HERE. IF U-CLIPS ARE TURNED INCORRECTLY,
YOU WILL DO IRREPARABLE DAMAGE TO YOUR TABLE WHEN YOU ATTEMPT
TO OPEN IT TO THE PLAYING POSITION.
3. Align the holes in the U-clips #3 with Indentations in table
top assembly and secure with twelve screws #20 as
shown. All four holes in each U-Clip must align with four
Indentations in top. See Figure 2 and Detail A.
If you want to see a video on how to position the U-Clips go to:
http://www.escaladesports.com/customer-service/videos.html
Or scan with your smartphone:
IMPORTANT:
Be sure that slot in the three U-clips #3 all
face the same direction as shown. (Toward
the end of the table with no stripe.)
Figure 1
Figure 3
Figure 3
Note: Indentations are
small so look closely.
20
3
7
2
End Rail Mounting
Indentations
End Rail Mounting
Indentations
Figure 2
Figure 3
Figure 3
Detail A
Slot in
U-Clip
1