Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Lay out Side Rails #25 & 29 and End Rails # 26, around edges of
table top.
as shown in Figure 5.
8. Slide Left #36 and Right #35 Vinyl End Caps onto the ends of
the Side Rails #25 & 29 as shown in Detail D.
9. Line up holes in rails with indentations in top and secure using
eighteen screws #20. See Figure 5 & Detail D.
10. Lay Corner Caps #22 on table as shown in Figure 5. If
Corner Cap sticks above the table top surface of the table,
flip over so shorter distance is against edge. Secure to
bottom of table with three Screws #21. See Detail E.
Note: To aid in assembly you can use a cordless drill and
Phillips bit for Step 11 only. Wear safety glasses.
11. Insert Screw #19 through slot in U-Clip #3 and
into U-Support #7. Thread it all the way into U-
Support #7 until it touches the back of the tube.
There should be about 3/8 inch of screw #19 left
sticking out. Do not insert screw in middle #3
U-Clip. See Detail F.
If you want to see a video on how to insert Screw (#19) go to:
http://www.escaladesports.com/customer-service/videos.html
Or
Scan with your smartphone:
29
20
Figure 3
Figure 5
Figure 3
7
19
3
7
Note: Rotate U-Support #7
until you see the screw hole
in the slot of U-clip #3.
Slide U-support #7 side to
side and front to back if
necessary.
Detail F
5
Note: Rails attach
with #20 screws
20
26
Detail E
25
Note: Rails attach
with #20 screws
20
35 (RH)
Detail D
Publicidad
