Publicidad
Idiomas disponibles
Idiomas disponibles
12. Attach end of linkages #4 with two holes to INSIDE of Leg #2 as shown in Detail
G & Detail H. Secure through end hole with screws #23, locknuts #15 and
plastic spacers #31. Tighten hardware snug enough to keep table stable but do not
overtighten. Tubes must pivot freely.
13. On one side of the table attach slotted end of safety strap #6 to INSIDE
of Leg #2 using one bolt #39, one spacer #30, one washer #24, and
one hex nut #15. Tighten hardware until snug but do not overtighten.
Tubes must pivot freely. See Detail H.
14. Attach other end of safety strap #6 to OUTSIDE of linkage #4
using one bolt #9, one washer #24, one spacer #30, and
one hex nut #15 as shown in Detail H.
Important! Do NOT put other safety strap #6 on this
table half. It will be installed on second table half later.
15. Gently tap caster sockets #12 into U-support #7 until flange
on sockets touches the edge of the tube. DO NOT HIT
CASTER SOCKET DIRECTLY WITH A HAMMER! SET A
PIECE OF WOOD ON CASTER SOCKET AND HIT PIECE
OF WOOD TO DRIVE CASTER SOCKET INTO U-
SUPPORT.
16. Insert casters #11 into caster sockets #12.
See Figure 6A.
2
30
39
24
9
24
23
Detail H
31
6
First Table Top
Figure 6A
Figure 3
Figure 3
15
6
4
30
15
11
12
7
4
15
4
2
23
31
Detail G
Publicidad
